Lauda ECO Silver E 4 S, Operation Manual

Page: 101 / 128

10/2019 i
ECO Silver 101 / 124
1. Activating external control (

B.1).
2. Set the slave controller:
2.1. Parameter to auto ;
Xpf in dependence of:

Check or adjust device type (

8.2.4).

Select heat transfer liquid with as low-viscosity and with as high a thermal capacity as possible.
Ranking list: Water, water/glycol, oils, Fluorinert®.
 Set pump level as high as possible,
 Make sure there is adequate circulation,
 select the hose length as short as possible, e.g. 2 x 1 m,
 select the hose cross-sectional area as large as possible, e.g. ½ inch,
 set the throughput through the external consumer as large as possible.
2.2. Set Xpf:

With a tendency to oscillate with a short period of oscillation (e.g. 30 s)

Xpf smaller, otherwise larger,

with poor thermal coupling and a large mass to temper

large (e.g. 2 – 5, possibly even larger),

with good thermal coupling and a small mass to temperature-stabilize

small (e.g. 0.2 – 0.7),

if fast temperature changes are required, external baths should be controlled if possible with internal control. Other-
wise choose Xpf to be very small (0.05 – 0.1).
3. Setting the master controller (PID controller):
 First start with Auto, then possibly continue with manual.
3.1. Setting Kpe:
 With a tendency to oscillate (long period of oscillation, e.g. 10 min)

Kpe larger, otherwise smaller,
3.2. Setting Tne/ Tve/ Tde:
 Generally quite high values (Tne = 70 s – 200 s; Tve = 50 s – 150 s),

with smaller values

faster transient responses, otherwise slower transient responses and therefore less oscillation,

Tve: To reduce transients

increase Tve, otherwise vice versa,

Tde (damping for Tve): generally approx. 10 % of Tve.
4. Correcting quantity limit (

E.1.1) and temperature limits (Til/Tih) (

7.4.5):

Set according to the physical boundary conditions.
Example:
Heat transfer liquid Correcting quantity limit Til Tih
Water depends on heat transfer liquid and vessel 5 °C 95 °C
E. 2 .2 Procedure for setting the control parameters for external control