Unrolling the Cover
Standing behind the housing looking over
the pool, unroll the cover from left to right.
Running Ropes Through the
Tracks
The preferred method of running the rope is
to pierce the rope with a 1’ length of wire
and use it as a handle to feed the rope
through the track.
Feed the rope into the water side channel of
the track with the wire extending out the
side of the track. Use the wire to pull the rope
down the length of the track towards the
end of the pool.
Feed the rope through the pulley assembly
(17) and insert the pulley housing into the
end of the track.
Feed the rope into the back channel then
pull the rope down the back side of the track
toward the cover housing.
Pull all excess rope through the cover track.
Complete the fastening of all track screws
flush on the top of the track. Clean concrete
dust from track and pulley end cap. Make
sure ALL screws are flush with the top of the
tracks.
2
3
4
5
6
7
8
9
Routing the Ropes
Begin with the rope on the motor end. Feed
the wire that is attached to the
rope
around
the first
and second pulleys.
1
Step By Step Instructions
Numbers shown in parenthesis refer to hardware shown on page 3.
© Latham Pool Products, Inc. 201
9
. All rights reserved.
Opening the Cover
To open the cover box, cut the bands that
hold the two halves of the box together.
Never cut the top of the box open. Doing this
could easily damage the cover inside. This
kind of damage is not covered under the
fabric warranty. With the bands cut, lift and
remove the top box.
12