Step By Step Instructions
Position the motor end and non-motor end
of the mechanism roughly in the position
that they will mounted.
Attaching the Roll-up Tube
With the non-motor end turned upside down,
attach the cone for the non-motor end to the
roll-up tube using the 3/8” x 1
-
1/4” bolts (28)
and lock washers (23) provided.
Positioning the Mechanism
Place the mechanism on the pool deck
roughly in the position that it will be
anchored.
Extend the Pulley Brackets
Use a 7/16” wrench to loosen the nylock
nuts on the adjustable brackets of the non-
motor and motor end of the mechanism.
Install one mounting foot on the motor end
and one on the non-motor end using the 1/4
x 20 bolts (32) provided. Tighten securely.
Turn the mechanism over. Extend the pulley
brackets so they will match the elevation set
by the mounting foot. This height is
adjustable depending on the length of the
cover.
With the mechanism and tube assembled,
check the roll-up tube for level. If the deck
isn’t level, the distance from the deck to the
tube should be the same on both ends of the
tube.
This is crucial for a properly operating cover.
Adjust the non-motor end as needed to level
the roll-up tube.
1
22
4
5
6
7
8
9
With the motor end turned upside down,
attach the cone one the motor end using
the same bolts (28) and lock washers (23).
Tighten the bolts with a 9/16” wrench.
Make sure the pulley brackets are spread
wide enough to provide good stability.
3
Numbers shown in parenthesis refer to hardware shown on page 3.
© Latham Pool Products, Inc. 201
9
. All rights reserved.
8