Direct this rope under the rope reel, over the
rope containment bracket and out of the
mechanism.
On the non-motor end, feed the wire that is
attached to the rope around the pulley and
out the back channel of the pulley assembly.
Pull this rope to the motor end pulley
assembly.
Insert the wire that is attached to the rope
into the channel behind the first pulley.
Continue to push the wire until it comes out
of the channel behind the third pulley.
Bend a curve into the end of the wire and
pull it back just until it is in the middle of
the pulley. Now push the wire back until it
comes out the side of the third pulley.
Pull the rope under the rope reel, over the
rope containment bracket and out of the
mechanism.
Attaching The Cover Leading
Edge
Lay the front of the cover in front of
the mechanism. Slide the leading edge
through the loop on the front of the cover.
Attach the detachable rope tab to the three
hole plate on the wheel assembly.
Place the nylon leading edge inserts into
the ends of the leading edge tube. Make
sure they can slide freely inside the leading
edge tube.
Connect the two hole bracket that is
attached to the front corners of the cover to
the wheel assemblies.
10
11
12
13
14
15
16
17
18
Step By Step Instructions
© Latham Pool Products, Inc. 201
9
. All rights reserved.
13
