LaserMech FiberCUT 2D, Operation Manual

Page: 56 / 68

PLMNL0232 REV. H Effective Date: 01/14/19
56
FiberCUT
®
2D Operation Manual
12.2 PROFINET I/O Mapping
The GSDML file is available for download at http://www.lasermech.com/fibercut2dupdates
SLOT MODULE NAME
1 Input 001 byte Fault Digital Outs
2 Input 001 byte Status Digital Outs
3 Input 002 bytes HSU Voltage
4 Input 002 bytes Process Monitor
5 Input 002 bytes Purge Pressure
6 Input 002 bytes Lens Position
7 Input 002 bytes Process Monitor Temp
8 Input 002 bytes Electronics Temp
9 Input 002 bytes Collimator Temp
10 Input 002 bytes Upper CG Temp
11 Input 002 bytes Lens Temp
12 Input 002 bytes Lower CG Temp
13 Input 002 bytes Nozzle Temp
14 Input 002 bytes HSU Curve
15 Input 002 bytes Aux Out Setting
16 Input 002 bytes Focus Position
17 Input 002 bytes Maximum Position
18 Input 002 bytes Process Monitor Gain
19 Output 001 byte Config Bits
20 Output 001 byte Command Bits
21 Output 002 bytes Set Position
22 Output 002 bytes Set HSU Curve
23 Output 002 bytes Set Aux Out
24 Output 002 bytes Set Focus Position
25 Output 002 bytes Set Process Monitor Gain

Fault Digital Outs
BIT 7 BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 BIT 0
No
Comm.
Position
Error
Temperature
Fault
Purge
Fault
Lens
Fault
HSU Fault

Status Digital Outs
BIT 7 BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 BIT 0
Reserved For
Future Use
Cal Ack.
Reserved for
Future Use
Lens in
Position
Lens at
Zero
TOUCH READY

Config Bits
BIT 7 BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 BIT 0
Reserved For Future Use
Suppress Low
Purge Fault

Command Bits
BIT 7 BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 BIT 0
Reserved For Future Use
Zero
Pressure
Move
Lens
Reset CAL
ITEM DESCRIPTION
Device Name ABIC-PRT