LaserLine Flatwork Ironer Series, Instruction Manual

Page: 13 / 238

GL16 Introduction
1-1
Chapter 1
INTRODUCTION
This chapter contains the following sections:
1.1 Warranty
1.2 Scope of Manual
1.3 Safety
The GL16 Gas-Heated Flatwork Ironer (Figure 1-1) is a one-piece unit that dries and irons sheets,
pillowcases, table linen, and other types of flatwork. The unit will process polyester/cotton blends, VISA
®
,
or all-cotton fabrics. This unit is available with ironing cylinder lengths from 60" to 135"
(1,525 mm to 3,430 mm). Type F units discharge flatwork to a front receiving shelf. Type R models can
be switched to discharge flatwork to either the front or rear receiving shelf.
Like the rest of the CHICAGO

product line, the GL16 is designed, manufactured, and assembled in
Chicago, Illinois. Before the CHICAGO

nameplate is affixed to any unit, a final inspection is performed,
including thorough testing under load conditions.
Any questions concerning the installation, operation, or repair of the unit should be directed to a local
authorized CHICAGO
®
dealer or the factory Service Department at:
!
Chicago Dryer Company
2200 North Pulaski
Chicago, Illinois 60639
"
(773) 235-4430
Fax (773) 235-4439
Email service@chidry.com
1.1 Warranty
A full page warranty statement is located at the front of this Instruction Manual . Please take the
time to review this warranty and understand its provisions.
Figure 1-1: The GL16 provides high quality flatwork finishing.