LaserBit PicoPlus Series 1.0 page
17
8 The mounting bracket
In the following chapter you will find detailed description of the bracket fastenings.
8.1 Mounting Bracket for Picos
Laserbit
provides the mounting bracket and all the necessary components for
Pico II
units. A simple fixing technique of this bracket can be seen on the following
figure, required tools are as follows:
- drilling
machine
- 10 mm wrench
Bracket sizes:
Length:
329mm
Leg
Width:
209mm
Head
Width:
100mm
Drill size:
10mm wall drilling
Installation steps:
•
Place the bracket on the wall
•
Mark the wall with a permanent marker
•
Use your 10mm wall drill to drill all of the holes into the wall
•
Clean the holes
•
Place the wall-plugs into the holes (please note that some times you need to
use hammer to put the wall-plugs into the hole, if you have to please be
careful not to break the wall-plug
)
•
Place the bracket to the wall an line it up to the holes
•
Put the screws into the wall-plug through the hole on the leg of the bracket
(please see the figure above)
•
Tighten up the screws
Packet list for the bracket:
3pcs 8x110 screw for bracket fixing
3pcs 8x100 plastic wall-plug for bracket fixing
2pcs M6x90 bolt Head fixing
3pcs M6x25 screw Head fixing
3pcs M6 bolt head fixing
6pcs 6mm spacer bracket and head fixing
6pcs 6mm spring spacer bracket and
head fixing
