LaserBit PicoPlus Series 1.0 page
20
9.1.2 Alignment of the heads
•
Target Side B with the crosshair
built in to the head on Side A
•
Repeat the first step with Side B!
•
Power up the heads!
•
Screw the three nuts up tight on
both heads, which were used for
the head fastening, but be
careful that the heads do not
move out from its position!
•
Screw the two nuts up tight on
both heads, which are used for
the fixing the vertical direction,
but be careful that the heads do
not move out from its position!
Meanings of the LEDs
Power:
The head is powered up.
FO Link:
Fibre optical link between
the two heads.
TP Link:
Copper link between
the head and the Network
equipment.
RX OK:
There is enough light to
start communicate through
the link.
Level 1:
25% of the total (acceptable by the receiver) incoming power
Level 2:
50% of the total (acceptable by the receiver) incoming power
Level 3:
75% of the total (acceptable by the receiver) incoming power
Saturation:
Overload (Overloading can cause stop in the communication, and permanently it can
damage the receiver)
