LaserBit PicoPlus Series 1.0 page
19
9.1.1 Fixing the heads
Your
PICO PLUS
head can be fixed to
its stand with the three M6x25 bolts.
On the figure you can see a plinth of a
PICO PLUS
unit, a head of a
PICO
PLUS
mounting bracket, and the
necessary fixing parts. The steps of the
fixing are:
•
First place the head to the stand
•
Place the bolts into the holes which
is easily accessible for the
installation and the two cuts
•
Place up the washers and spring
washers
•
Fix the bolts with the nuts
After you put up the washers and the nuts, do not screw the nuts up tight because of
the comfortable positioning (see the chapter of Alignment).
After the fixing, place the two M6x90 tangent bolts into the two of the four holes on
the corners of the plinth. The important is that the bolts have to be in opposite
corners. You can do the vertical fine alignment with these bolts.
