LaserBit Giga Series 4.3 page
39
•
After the heads are lined up with the sighting device, you have lined the units
into a negligent position
•
Following the LED’s you might require some fine
alignment with the spacers which you can see in the
figure! Depending on the distance this can be small or
large movements.
/Please note the larger the distance the less
movements are required for the fine alignment/
•
The Fine adjustments should be done as follows
1
Place the two spacers where the figure shows to.
Open the spacers until it reaches the bottom of
the upper plate of the ABU. Repeat this on the
back side too.
2
With these spacers you can manipulate the vertical state of the head and
necessary the beam too.
For the fine adjustment you need two
wrenches. With one of them you have to hold
the head of the bolt, and with the other you
can turn the thick nuts to lift or loose the plate
of the ABU.
3
Important to take note that both of the spacer have to fastened tight.
To not enable any movement on the vertical
angle of the head and due to the heat
expansion please close the locking nut under
the thick nut, as it shown on the figure, on
both sides
•
Repeat the steps 1-3 on the remote end as well.
•
Now the system is secured with the fine adjustment bolts. The long term
alignment bolts should be tightened on the bottom of the unit.
/Please note: During the tightening process should you experience some
movements. This should be compensated with further tightening of the fine
adjustment bolts/
