LaserBit Giga Series 4.3 page
37
Connecting the head to the ODIU, and the ODIU to the power
supply
Ensure that the cables are connected as it seen below.
For the power connection recommended to
use three-wired Ø0,75mm cables. The order
of the connection can be seen on the figure.
•
P – Phase
•
N - Neutral
The necessary power can be supported to the head by
the connector which can be seen in the figure next to this
text. Order of the cables from the head: (the four-twisted-
pair-wired cable)
•
Red - +12V
•
Black - -12V
•
Twisted green-yellow - GND
10.3.2
Fixing the heads
Your
GigaPINTO
head can be fixed to
its stand with an alignment base
unit(ABU). The ABU and its fixation to the
stand can be seen on the left figure. The
necessary nuts and washers can be found
on the legs of the ABU.
On the right figure you can see an ABU,
and a plinth of a
GigaPINTO
unit, and
the necessary fixing parts. The necessary
nuts and washers can be found on the
legs of the head. The steps of the fixing
are:
•
First, place the ABU to the stand
•
Fix the ABU to the stand using the washers and nuts
•
Place the head to the ABU
•
Fix the bolts with the nuts, using the washers
