Section 3 - Basic Operations
Page 7
Section 3 - Basic Operations
Battery
Installation
The TruPulse 200L is powered by a 3 Volt Lithium battery commonly referred to as
CR123A or also referred to as CR123.
1.
Remove the battery compartment cover by gently pressing the clip to release the
cover.
2.
Install the battery as shown in Figure #4A. The battery must be oriented (+/-) as
shown in the figure and also on the indication sticker found inside the battery
compartment.
3.
Replace the battery compartment cover by aligning the tab located on the top the
cover with the grooved edge of the battery compartment, and press the cover until
the tab locks into position.
Low Battery Warning
The TruPulse 200L monitors the incoming battery voltage.
Figure #5 shows the location of the battery status indicator.
•
When the voltage drops below 2.6V
, the BATT status
indicator flashes every 5 seconds, alternating with the
normally displayed information.
o
You should replace the batteries as soon as possible.
•
When the voltage drops below 2.4V
, the BATT status
indicator stops flashing and is displayed steady. At this
point, system operation is locked.
o
You must replace the batteries to return to normal
system operation.
Figure #4
Figure #5
1.
Battery Compartment
Cover
2.
Tab
3.
Clip
