Section 3 - Basic Operations
Page 7
Section 3 - Basic Operations
Batteries
Installation
You may use two AA batteries (or 1 CRV3 battery) to power the TruPulse. The CRV3 battery
provides approximately twice the usage time of the AA batteries.
1.
Remove the battery compartment cover by
gently pressing and sliding the cover in and down
as shown in Figure #4A.
2.
If using AA batteries
, install the batteries as
shown in Figure #4B. Batteries must be
oriented (+/-) as shown in Figure 4B and also
on the indication sticker found inside the
battery compartment.
o
If using one CRV3 battery
, the battery
compartment is designed so the battery
will only fit one way.
3.
Replace the battery compartment cover by
aligning the tabbed edges of the cover with the
grooved edges of the battery compartment, and
slide the cover up until the tab locks into position.
Low Battery Warning
The TruPulse monitors the incoming battery voltage. Figure #5 shows the location of the battery
status indicator.
•
When the voltage drops below 2.2V
, the BATT status
indicator flashes every 5 seconds, alternating with the
normally displayed information.
o
You should replace the batteries as soon as possible.
•
When the voltage drops below 2.0V
, the BATT status
indicator stops flashing and is displayed steady. At this
point, system operation is locked.
o
You must replace the batteries to return to normal
system operation.
Figure #4
Figure #5
Summary of Contents for TruPulse 200
Page 1: ......
