Section 6 - Target Modes
Page 25
Section 6 - Target Modes
The TruPulse has five Target Modes which allow you to select or eliminate targets and to take the
most accurate measurements possible in various field conditions.
1.
From the Measurement Mode, press
for 4 seconds. The
active Target Mode appears in the Main Display.
2.
Press
or
to display the previous or next Target
Mode.
3.
Press
to select the displayed Target Mode and return to
the Measurement Mode.
o
Std = Standard: Single shot mode.
o
Con = Continuous: Press-and-hold
. Once the target is
acquired, the TruPulse can continuously acquire additional
targets for a maximum of 10 seconds. The most recently
acquired target appears in the Main Display.
Note: The MULTI indicator is not displayed in this mode.
o
CLO = Closest: Press-and-hold
. Once the initial target
is acquired, the TruPulse can acquire additional targets. The
MULTI indicator denotes that additional targets have been
acquired. The closest acquired target always appears in the
Main Display.
o
FAr = Farthest: Press-and-hold
. Once the initial target
is acquired, the TruPulse can acquire additional targets. The
MULTI indicator denotes that additional targets have been
acquired. The farthest acquired target always appears in the
Main Display.
o
Flt = Filter: In this mode the laser’s sensitivity is reduced to
only detect pulses returned from a reflector. The optional
foliage filter must be used in conjunction with this mode. In
this mode, measurements always include ‘F’ as the left most
character in the Main Display. Typical maximum distance is
107 meters
(350 feet) to a 3-inch reflector.
•
The selected Target Mode remains active until you repeat the above steps
and select a different Target Mode.
•
Each time the TruPulse is powered ON, it will return to the same Target
Mode that was last used.
•
In Closest and Farthest Modes, the minimum separation distance between
targets is approximately 20 meters (66 feet).
Figure #21
Summary of Contents for TruPulse 200
Page 1: ......
