Larson Electronics LLC www.LarsonElectronics.com [email protected]
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
Use as Spot Light
Pressing the “Spot Light” button will narrow the beam angle. The light beam will be more focused and
is suitable for far illumination.
Use as Flood Light
Pressing the “Flood Light” button will widen the beam angle. The light beam will be a wider spread and
is suitable for near-field peripheral illumination.
Pan Light
Press the “Pan Clockwise” or “Pan Counterclockwise” button to rotate the light up 355° clockwise or
counterclockwise.
Tilt Light
Pressing the “Tilt Up” or “Tilt Down” button will tilt the light up or down between -30° to +180°.
Control Groups of Lights
Each remote can be programmed to control two groups of lights. Each group can include unlimited
number of lights. A light can only be assigned to one group of one remote control. Press “Select 1
st
Group of Lights” button to select group one of lights. Press “Select 2
nd
Group of Lights” button to select
group two of lights. The two groups can be selected individually or together. When a group selection
button is on (selected), the remote control functions will apply to all of the lights included in that
group. NOTE: While a remote control can pair with many lights, a light can be paired with one Select
Group button of one remote control. Always send a light together with its paired remote control. If a
light is paired with a new remote, the old remote will not work with that light anymore.
Pair a Light with a Remote Control
Each remote control has a programming magnet on the upper left corner. There is N-Mark below the
antenna of a light. Follow the steps below to pair a light with a group of a remote control:
a)
Make sure the remote control is turned off.
b)
Continuously touch the programming magnet on the remote control to the N-Mark of the light.
c)
Connect and turn on power to the light while holding the magnet on the N-Mark. The light will
not start the self-reset process. Instead the light will blink. Once the light blinks, the
programming magnet does not need to touch the N-Mark.
d)
While pressing and holding down one of the two “Select Group of Lights” buttons, press and
hold the “Remote Control Power Switch” until a green indicator light comes on.