LxT Manual
Measurement History
10-1
C H A P T E R
10
Measurement History
This chapter describes Measurement History setup and
operation, as well as the data displays associated with the
feature. The optional firmware LXT-ENV must be
enabled to perform measurement history (Timed Stop
and Continuous Run Modes)
Enabling Measurement History
Before beginning to work with
measurement history, become
familiar with the setup of Run
Modes, as described in the chapter
entitled “Run Modes.”
You can perform a sequence of measurements either
manually or automatically that are stored in a single file.
To enable Measurement History, follow these steps:
Step 1
Press the Menu softkey.
Step 2
Select
Settings
and press
5
(ENTER).
Step 3
Navigate to the
Control
tab.
Step 4
Press
5
to select the run mode.
Step 5
Navigate down to the
Enable Measurement
History
option and press
5
to select the check box, as
shown in FIGURE 10-1.
Step 6
Depending on the run mode selected, define the
measurement time durations, as described in the following
section.
FIGURE 10-1 Measurement History Setup
Summary of Contents for SoundExpert LxT
