9
Copyright LapSafe® Products
The Traveller™ Charge & Sync Range - User Manual
Figure 12
Routing leads to device slots
Figure 13
Feeding cables through
LapSafe® Travellers™ with plastic storage compartments
With the central cover piece removed, feed each USB charge/sync lead through
the end of the central slot and route it to one of the storage compartments.
Measure the required amount of charge/sync lead to remain above the surface
of the plastic and secure the lead to the plastic tab using a cable-tie (
Figure 12
& 13
). Position the locking end of the cable-tie inside central slot and repeat for
each lead.
Avoid tangles by fitting each individual lead separately and stow any excess lead
into the central slot below the cable ties.
When all 16 leads are in position the cover piece can be replaced.
Once cabling is finished
Load your tablets into their individual storage compartments and connect a
charge/sync lead to each device.
(Make sure the charge/sync connectors all face upwards)
Note:
The foam in the lid of the LapSafe® Traveller™ allows room for the
connectors when the lid is closed.
