7: Setup Mode: Server Configuration
UDS1100 User Guide
40
Note:
When you enter Monitor Mode from the serial port with network connection
enabled and issue the
NC (Network Communication) command, you see the
unit’s IP configuration.
There are three methods for assigning DHCP names to the unit.
Default DHCP Name
: If you do not change the DHCP name, and you are using an IP
of 0.0.0.0, then the DHCP name defaults to XX.XX.XX.XX (XXXXXX is the last 6
digits of the MAC address shown on the label on the bottom/side of the unit). For
example, if the MAC address is 00-20-4A-12-34-56, then the default DHCP name is
C123456.
Custom DHCP Name
: You can create your own DHCP name. If you are using an IP
address of 0.0.0.0, then the last option in Server configuration is
Change DHCP
device name
. This option allows you to change the DHCP name to an alphanumeric
name (LTX in our example).
Change DHCP device name (not set) ? (N) Y
Enter new DHCP device name : LTX
Numeric DHCP Name:
You can change the DHCP name by specifying the last octet
of the IP address. When you use this method, the DHCP name is LTXYY where YY
is what you chose for the last octet of the IP address. If the IP address you specify is
0.0.0.12, then the DHCP name is LTX12. This method only works with 2 digit
numbers (01-99).
