Lantronix
ION219-x Install Guide
33412 Rev. D
21
Ground Installation
To ground the ION219-A chassis, do the following:
1. Obtain one (1) properly terminated, grounding conductor (12 AWG copper wire gauge or larger) with a two-
hole, compression-type, grounding connector. Note the manufacturer's applied torque required for the
connector.
2. Attach the grounding conductor to the chassis by placing the two-hole, compression-type connector onto the
grounding lugs and then fasten with the appropriate lock-washers and lug nuts at the proper torque. See Figure
10 below.
3. Attach the opposite end of the properly terminated grounding conductor to the Common Bonding Network
(CBN) for telecom installations, or to an approved grounding system (if required) for non-telecom installations.
Figure 10: Grounding the Chassis
Chassis Slide-In Cards (SICs) and IONMM Installation
Refer to the user guide for each SIC for specific information on the cables, connectors, and LED indicators of the
individual SICs.
