Lantech LGS-2624C, User Manual, Page: 189 / 279

Parameter description:
QCE#
Indicates the index of QCE.
Switch
Indicates the switch id on which QCE entry is configured. 'Any' indicates
QCE is configured on all the switches in the stack.
Port
Indicates the list of ports configured with the QCE.
Frame Type
Indicates the type of frame to look for incomming frames. Possible frame
types are:
Any: The QCE will match all frame type.
Ethernet: Only Ethernet frames (with Ether Type 0x600-0xFFFF) are
allowed.
LLC: Only (LLC) frames are allowed.
LLC: Only (SNAP) frames are allowed.
IPv4: The QCE will match only IPV4 frames.
IPv6: The QCE will match only IPV6 frames.
SMAC
Displays the OUI field of Source MAC address, i.e. first three octet (byte) of
MAC address.
DMAC
Specify the type of Destination MAC addresses for incoming frame.
Possible values are:
Any: All types of Destination MAC addresses are allowed.
Unicast: Only Unicast MAC addresses are allowed.
Multicast: Only Multicast MAC addresses are allowed.
Broadcast: Only Broadcast MAC addresses are allowedd.
The default value is 'Any'.
VID
Indicates (VLAN ID), either a specific VID or range of VIDs. VID can be in
the range 1-4095 or 'Any'
Conflict
Displays QCE status. It may happen that resources required to add a QCE
may not available, in that case it shows conflict status as 'Yes', otherwise it
is always 'No'.Please note that conflict can be resolved by releaseing the
resource required by the QCE and pressing 'Refresh' button.
Action
Indicates the classification action taken on ingress frame if parameters
configured are matched with the frame's content.
There are three action fields: Class, DPL and DSCP.
Class: Classified QoS Class; if a frame matches the QCE it will be put in the
queue.
DPL: Drop Precedence Level; if a frame matches the QCE then DP level
will set to value displayed under DPL column.