Lanner R6S, User Manual

Page: 83 / 89

R6S User Manual
83
The system comes with a controller to ensure that the device is well-shielded against premature failure
at the boot or shutdown phase. When installing:
1. Make sure both your vehicle and the system are turned off.
2. Follow the wiring definition and illustration below to connect the vehicle battery and ignition
(ACC) to the in-vehicle system through the 5-pin M12 male connector marked
as “DC Input” on
the system, through the right pin contact.
In a typical in-vehicle computing solution, this system usually acts as a PSE (Power Sourcing Equipment)
to power up connected PoE devices, for which you should ensure a minimum of 48V DC power supply to
the system with the use of a
DC to DC Adapter.