8
INSTALLATION CONT.
Install the Griddle into the Cabinet
Turn the griddle over, taking care not to kink or pinch any sensor wires. Set the griddle on the table that
it is to be installed in (leaving a hole big enough to slip the control panel through).
Insert the control panel through the hole and out of the control opening of the cabinet.
The hole must be such that the control box can come out of the cabinet 18” for serviceability.
Lower the griddle plate to sit flat in the table opening.
Electrical Connection
The electrical connection must be made in accordance with local codes or in the absence of local codes
with NFPA No. 70; latest edition (in Canada use: CSA STD. C22.1).
A power connection box is provided for power connection.
This box must be installed a minimum of 18” from the heating elements in the cabinet box.
All electrical connections can be made at this box.
The griddle can now be connected to power.
DANGER:
THIS APPLIANCE MUST BE GROUNDED AT THE TERMINAL
PROVIDED. FAILURE TO GROUND THE APPLIANCE COULD
RESULT IN ELECTROCUTION AND DEATH.
INSTALLATION OF THE UNIT MUST BE DONE BY PERSONNEL
QUALIFIED TO WORK WITH ELECTRICITY AND PLUMBING.
IMPROPER INSTALLATION CAN CAUSE INJURY TO PERSONNEL
AND/OR DAMAGE TO EQUIPMENT. UNIT MUST BE INSTALLED IN
ACCORDANCE WITH ALL APPLICABLE CODES.
NOTICE:
The data plate is located behind access panel between controls and
grease drawer. The grill voltage, wattage, serial number, wire size,
and clearance specifications are on the data plate. This information
should be carefully
read and understood before proceeding with the installation.
NOTICE:
The installation of any components such as a vent hood, grease
extractors, fire extinguisher systems, must conform to their
applicable National, State and locally recognized installation
standards.
ALWAYS KEEP THE AREA NEAR THE APPLIANCE FREE FROM
COMBUSTIBLE MATERIALS.
KEEP FLOOR IN FRONT OF EQUIPMENT CLEAN AND DRY.
IF SPILLS OCCUR, CLEAN IMMEDIATELY, TO AVOID THE DANGER
OF SLIPS OR FALLS.
BE SURE THE POWER SUPPLY VOLTAGE MATCHES THE VOLTAGE
SPECIFIED ON THE NAMEPLATE LOCATED ON THE TOP OF THE
CONTROL BOX
CAUTION
WARNING
WARNING
Summary of Contents for 136TDI
Page 19: ......
