Landoll Brillion SSB, Operator'S Manual

Page: 40 / 102

2-18 1P480rev0718
ASSEMBLY
Seed Shaft Sensor Kit - Small
Seed Box
1. Remove the four 10-24 x 3/4 Self Tapping Screws
from the Magnet Wheel Assembly. See Figure 2-24.
Position the rounded half of the Magnet Wheel
Assembly on the seed shaft. Ensure it fits squarely
onto shaft. Mount magnet half to the rounded half.
Ensure it fits squarely onto shaft.
2. Fasten the two halves together using four #10-24 x
3/4 Self Tapping Screws. Do not over tighten .
3. Identify the seed cups on either side of the Magnet
Wheel Assembly and remove the 1/4-20 hardware.
4. Insert Sensor into Shaft Sensor Bracket slot. Note: 8
and 10 foot seeders use Sensor Bracket with 8-1/2”
spacin
g.
5. Insert a 1/4-20 x 3/4 Machine Screw into each seed
cup. Align the Shaft Sensor Bracket with the two
1/4-20 x 3/4 Screws. Secure with existing Lock
Washers and Nuts.
6. Slide/Position Seed Shaft Sensor so it is 1/8” from
the magnet. See Figure 2-23. Tighten both Retaining
Nuts.
Figure 2-23: Small Box Seed Sensor
0D[
0DJQHW
6HHG6KDIW
6HQVRU
6KDIW6HQVRU
%UDFNHW
0DJQHW:KHHO
$VVHPEO\
6HHG6KDIW6HQVRU'LP