Landoll Brillion SSB, Operator'S Manual

Page: 28 / 102

2-6 1P480rev0718
ASSEMBLY
Hydraulics

WARNING
Tightening Procedure for JIC 37 degree Swivel
Female Nuts.
1. Check Fitting Flare and seat for defects.
2. Lubricate the connection.
3. Install Hydraulic Hoses without twists.
4. Hand Tighten until connections bottoms.
5. Using 2 wrenches to prevent twisting, rotate the
Swivel Nut 2 wrench flats (1/3 turn).
6. For reassembly, follow the same procedure but
tighten only 1 wrench flat (1/16 turn).
Tightening Procedure for Swivel O-Ring Fittings.
1. Lubricate O-Ring and install the Fitting until the Metal
Washer which backs up the O-Ring contacts the face
of the boss.
2. Orient the Fitting by turning counterclockwise up to 1
turn.
3. Tighten the Locknut using 50-60 ft-lbs of torque. See
“Hydraulic Fitting Torque Specifications” on
page 4-2
.
Figure 2-9: Leak Detection
1. Restrictors installed in Cylinder Ports, connect 45
Degree Fitting so they are free to swivel. Connect top
Hydraulic Hose to the Cylinder Base and bottom
Hydraulic Hose to the Cylinder Rod End. Position the
Hydraulic Hoses so that the Cylinder Base End
points downward and the Cylinder Rod End points
upward. Merge Hydraulic Hoses together and Tie
Wrap them together about 12 inches from the Hose
End.
See Figure 2-10. Be sure that the Hoses
cannot sag and make contact with the Front Roller
Wheels.
Figure 2-10: Cylinder Fittings Positioning
2. Route the Drawbar Hydraulic Hoses along Drawbar
toward the Tractor. Secure Hoses to Drawbar with
Hose Clamp Pairs, Top Plate and 1/4-20 x 1-1/2 Bolt.
See Figure 2-11.
Escaping fluid under pressure can be nearly
invisible and have enough force to penetrate the
skin causing serious injury. Using a piece of
cardboard, rather than your hands, to search for
suspected leaks. Wear protective gloves and
safety glasses or goggles when working with
hydraulic systems.
'HJ)LWWLQJ
SRVLWLRQHGGRZQZDUG
'HJ)LWWLQJ
SRVLWLRQHGXSZDUG
%RWWRP
+\RVH
7RS+\GUDXOLF
+RVH
+\GUDXOLF
&\OLQGHU
7UDQVSRUW/RFN
7LH:UDS
2RVH&\O&RQQHFWLRQ