Landoll Brillion SSB, Operator'S Manual

Page: 60 / 102

2-38 1P480rev0718
ASSEMBLY
Coil Tine Track Remover Kit -
Optional
NOTE
Cannot be used with the Scraper Kit
1. Slide the Coil Tines onto the Round Bar so that the
straight leg is frontward. See Figure 2-49.
2. Mount an Arm Weldment and a Coil Tine to the
Round Bar second hole from the right end and the
third hole from the left end with 3/8-16 x 3 Bolts, Flat
Washers, Lock Washers and Nuts.
3. Mount the Coil Tines to the Round Bar with 3/8-16 x
2-1/2 Bolts, Flat washers, Lock Washers and Nuts.
4. Position the Brackets on the Seeder Frame Tube and
attach with 1/2-13 U-Bolts, Lock Washers and Nuts.
Do Not tighten at this time.
5. Attach the Adjusting Angles to Brackets with Lock
Screws. Secure the Adjusting Angles vertically to the
Brackets with a 1/2 x 1-1/4 Clevis Pin and Hair Pin
Cotter.
6. Attach the Arm Weldment to the Adjusting Angles
with 1/2-13 x 1-3/4 Bolts and Locknuts. Tighten the
Locknuts to allow free side to side swinging.
7. Center each Coil Tine Track Remover Assemble
behind the Tractor Tires. Tighten the Bracket U-Bolts
on the Seeder Frame Tube.
8. On each Coil Tine Track Remover Assemble, attach
a Chain End Link to an Adjusting Angles with 3/8 x
1-1/4 Bolt, Flat Washer, Lock Washer and Nut.
Drape the chain across to the other Adjusting Angle
and place the Chain in the Adjusting Angle Slot
ensure that the chain
The vertical position can be changed by removing the
Clevis Pins and Lock Screws and moving the Adjusting
Angles up or down.
To inactivate the Coil Tines, remove the 1/2 x 1-1/4
Clevis Pins and loosen the Lock Screws. Swing the Coil
Tine Bar Assembly upward and sideways. Hold Coil Tine
Bar Assembly in place by wrapping the Chain under the
Round Bar and placing the Chain into the Adjusting
Angle Slot. Re-tighten the Lock Screws. Insert Clevis Pin
into Adjusting Angle for storage.