Landoll 1230 Series, Operator'S Manual

Page: 20 / 64

3-10 CUTTER FRAME AND CUTTERS
3-10.1 Attach pivoting support brackets on main
frame front bar with 3/4" x 5-5/8" U-bolts,
lock washers and nuts (See Figures 3-14,
3-15, & 3-16) .
Notes:
See Figures 3-38 - 3-45 for assembly layouts.
Rigid frame models use two brackets; folding
frames use six.
Brackets must pivot freely on pivot bolts. If not,
loosen bolts to provide 1/16" clearance.
3-10.2 Attach cutter frame to support brackets
with disc cutter support at same location.
Use four 3/4" x 8" cap screws, lock washers,
nuts (See Figure 3-15) .
Note: Install RH cutter supports on right and
LH cutter support on left. See next step.
3-10.3 Install disc cutter supports (See Figure
3-16) :
- RH cutter supports (hubs toward right side
of implement) on RH side.
- LH cutter supports (hubs toward left side of
implement) on LH side.
Use 3/4" x 7-7/8" U-bolts (5), lock washers,
nuts.
CAUTION
TO PREVENT POSSIBLE PERSONAL
INJURY, BE CAREFUL WHEN HAN-
DLING DISC BLADES AND COULTERS.
BLADES AND ARE SHARP!
3-10.4 Attach disc or coulter blades to hubs with
1/2" x 1-1/2" carriage bolts, lock washers,
nuts.
3-10.5 Install cutter frame lift cylinder anchor (See
Figure 3-25) .
3-8
Figure 3-14 Pivoting Support Bracket for Cutter Frame
Figure 3-15 Pivot Bracket Installation
Figure 3-16 RH Wing Cutter Frame