Description of Unit
7/52
D000030875 en q
– E350 series 2, 1-phase ZCF100Ax/Cx – User Manual
© Gyr
With an AMR module, the meters can also be used to record counting
pulses of other physical media (e. g. water or gas volumes) or to directly
transmit values recorded by other measuring devices.
Any other application of these meters is regarded as abuse.
1.3
Field of Application
The basic version provides energy registers for tariffication, a red test diode
for active or reactive energy, an optical interface for meter reading and an
interface for various communication forms. This interface is protected against
fraud and is independent of the module suppliers. The exchangeable AMR
Module is situated outside the calibration liability. The functionality of this
meter is suitable for smaller consumers, e.g. for households.
The function of the disconnector is customer specific and is defined by the
communication module. Possible uses: anti-tampering (e.g. disconnection
in case of tampering with magnets), load limitation (fuse control), remote
disconnect (e.g. in case of change of tenant), prepayment. The status of
the disconnector is displayed on the meter, but the disconnector is
controlled by the communication module. If you need detailed information
on the functionality of your disconnector, please consult the user manual of
the communication module installed.
The basic series can be extended with various AMR Modules for additional
functions and communications:
Multirate import/export with external rate control
S0 pulse output
Communication via PLC, GSM/GPRS, or other media.
The meter functions which can be used in the system are defined by the
module (e.g. a 2 rate module is not able to control 6 rates in the meter).
Therefore, meter and module together define the functionality range which
can be used.
As the meter has a wide range of configuration possibilities, a specific
behaviour can in some cases differ from the description below.
The meters can be parameterised, i.e. specific parameters can be set with
software, so that the meters can be supplied according to the specific wishes
of the relevant utility.
Retroactive modification of the parameters is not possible.
The parameters stored in the meter are protected against unauthorised
overwriting.
Details about parameter settings can be found in the functional description.
Basic series
Disconnector
(ZCF100xB only)
Extensions
Parameterisation
