1 800 - LANDICE | [email protected] | WWW.LANDICE.COM
Lower Board Replacement
TOOLS NEEDED:
●
3mm and 4mm Allen Head Wrench
● Phillips Head Screwdriver
UNPLUG UNIT BEFORE STARTING
Begin by folding, then leaning the
treadmill up against a surface for easy
access to the motor cover. Using a
3mm
Allen Wrench, you will remove
11 bolts
in total:
7
on the bottom of the pan, and
2
on each wheel. Remove wheel plate on
each side, allowing you to remove the
cover.
Using your Phillips head screwdriver, remove the screw holding the lower board grounding wire in
place.
(Figure A)
Next, remove the two screws holding the lower board in place.
(Figure B)
Then, remove the upper harness connection.
(Figure C)
Next, locate the black/red drive motor wires and disconnect from the lower board.
(Figure A)
Finally, locate brown/blue wires and disconnect from the lower board.
(Figure B)
Remove the lower board. Reverse the instructions to install.
Removing the Motor Cover
Summary of Contents for M1
