Land Pride RCB5715, Operator'S Manual

Page: 33 / 86

Section 1: Assembly & Set-up
RCB5715 & RCBM5715 Rotary Cutter 337-046M 7/8/20
29
Table of Contents
Fold Lock Lugs Set-up
If the cutter is setup with Dual-Action Folding Cylinders
and folding lock lugs (#5) are arranged as shown in
Figure 1-25, then the lugs must be flipped around to be
like Figure 1-26. Follow steps 1-7 below to flip the lugs
around.
If the cutter is setup with
Single-Action Folding
Cylinders
and folding lock lugs (#5) are arranged as
shown in Figure 1-26, then the lugs must be flipped
around to be like Figure 1-25. Follow steps 1-7 below to
flip the lugs around.
Refer to Figure 1-24:
1. With wings unfolded on a level surface, remove all
nuts (#1), lock washers (#2), flat washers (#3),
bolts (#4), and the four folding locking lugs (#5). Set
hardware aside for re-use.
2. On both wing decks, flip folding lock lugs (#5) length
wise to be arranged as noted below.
•
For single-action cylinders, see Figure 1-25.
•
For dual-action cylinders, see Figure 1-26.
3. Install locking lugs (#5) with existing 5/8"-11x1 3/4"
GR5 bolts (#4), flat washers (#3), lock washers (#2),
and hex nuts (#1). Hand tighten hex nuts (#1).
4. Once all hardware has been reinstalled, start tractor,
and raise wings fully up.
5. Without relieving hydraulics, shut tractor down before
dismounting according to
“Tractor Shutdown
Procedure” on page 42.
6. Insert transport pins (#2) as shown in
Figure 1-22 on
page 28 .
7. Secure locking lugs (#5) to the wings by tightening all
nuts (#1) on both wing decks to the correct torque.
Fold Lock Lugs (#5) Set-up For Single-Action Cylinders
Figure 1-25
Fold Lock Lugs (#5) Set-up For Dual-Action Cylinders
Figure 1-26
70546
74192
TAPERED
END
74191
TAPERED
END
Fold Lock Lugs
Figure 1-24
74189