![background image](http://html1.mh-extra.com/html/land-pride/fc10/fc10_operators-manual_3522833011.webp)
Section 1: Assembly & Set-up
FC10 C-Tine Field Cultivator 335-043M
1/14/19
7
3-Point Hitch Assembly
Figure 1-1
39561
3-Point Hitch Assembly
1.
Remove 1/2" hex nuts (#3A), lock washers (#2) and
carriage bolts (#1). Keep removed hardware for
reuse.
2. Skip to step 5 if rear support channel (#10) is
mounted in the lower center 3-point hitch holes in
A-arms (#8) as shown.
3. If rear support channel (#1) is shipped mounted in
the top A-arms holes, remove hex nut (#4), lock
washer (#5), spacer (#6), and hex head bolt (#7).
Keep removed hardware for reuse.
4. Reattach rear support channel (#10) to the lower
center 3-point holes in A-arms (#8) as shown with
hex head bolt (#7), spacer (#6), lock washer (#5),
and hex nut (#4). Draw hex nut up snug, do not
tighten at this time
5. Make sure A-arm (#8) with decals is located on the
left hand side as shown. Attach A-arms (#8) to inside
of gussets (#11) with hitch pins (#15), spring lock
washers (#13), and hex nuts (#12) as shown. Draw
hex nuts up snug, do not tighten at this time.
6. Remove hex nut (#3B), lock washer (#2), and hex
head bolt (#9). Keep removed hardware for reuse.
7.
Attach rear support channel (#10) to the back of the
frame with 1/2" x 3 3/4" hex head bolt (#9), spring
lock washer (#2), and hex nut (#3B). Draw hex nut up
snug, do not tighten at this time.
8. Insert carriage bolts (#1) through gussets (#11) and
A-arms (#8). Secure carriage bolts with spring lock
washers (#2), and hex nuts (#3A). Draw hex nuts up
snug, do not tighten at this time.
9.
Refer to hitch pin detail:
On the right-hand side,
verify face of jam nut (#14) is 1 13/16" from center of
linchpin hole. If needed, adjust jam nut to the
correction distance.
10. Insert a drive punch into the linchpin hole (#16) and
rotate hitch pin (#15) until linchpin hole is vertical.
11. Tighten 7/8"-14 hex nut (#12) to the correct torque for
GR5 bolts
12. Repeat steps 9-11 for the left-hand side.
13. Tighten 1/2"-13 hex nuts (#3A & #3B) to the correct
torque for GR5 bolts.
14. Tighten 7/8"-14 hex nuts (#12) to the correct torque
for GR5 bolts.
15. Tighten 3/4"-10 hex nut (#4) to the correct torque for
GR5 bolt (#7)