Section 2: Options & Accessories Set-up
5/24/19
DB2660 & DBM2660 Ditch Bank Rotary Cutter 316-317M
24
Tailwheel (Optional)
Tailwheel 60" Deck Boom Arm . . . . . . . . . . 316-304A
Refer to Figure 2-1:
If included, tailwheel pivot (#1) and adjustment bracket
(#2) are shipped from the factory assembled to the deck.
1.
Remove bolts (#4) and cut zip tie (not shown)
securing tailwheel beam (#3) to pivot bracket (#1).
2.
Center tailwheel beam (#3) between tailwheel
adjustment bracket (#2) as shown and attach to
tailwheel pivot bracket (#1) with 5/8"-11 x 3 1/2" GR5
bolt (#5) and hex top locknut (#7).
3.
Draw hex top locknut (#7) up snug. Do not torque
locknut tight.
4.
Install one 1/2"-13 x 3 1/2" GR5 bolt (#4) below
tailwheel beam (#3) and another above the beam.
5.
Secure bolts (#4) with hex flange lock nuts (#6).
6.
Insert two machine washers (#8) over end of yoke
spindle (#10).
7.
Insert yoke spindle (#10) into tailwheel beam (#3).
8.
Insert one machine washer (#8) over end of yoke
spindle (#10) and secure tailwheel assembly to
tailwheel beam with roll pin (#9).
Side Gauge Wheel (Optional)
Refer to Figure 2-2:
Side Gauge Wheel . . . . . . . . . . . . . . . . . . . . 316-314A
If included, the side gauge wheel (#1) is shipped from the
factory fully assembled to the deck.
Weight Hanger Assembly (Optional)
Refer to Figure 2-3:
A right-hand overturning torque load is present on the
tractor when extension arm is fully extended. Auxiliary
weights can be added to the left rear tractor wheel to help
offset this overturning load. In addition, 100 lbs suitcase
type weights can be added to one of Land Pride’s six
optional weight hangers. Make sure your weights match
the weight hanger. The weight hangers are identified by
the company’s initials cut into the side plates.
CAUTION
!
To avoid minor or moderate injury:
Although weights can be added to minimize risk of overturing
tractor, the weights do not eliminate the risk. Caution should
be used at all times.
must
be installed for operation. See
on page 25 for detailed descriptions.
Weight Hanger Assy, John Deere . . . . . . . 316-230A
Weight Hanger Assy, Case . . . . . . . . . . . . . 316-231A
Weight Hanger Assy, IH . . . . . . . . . . . . . . . 316-232A
Weight Hanger Assy, Case/IH. . . . . . . . . . . 316-233A
Weight Hanger Assy, New Holland . . . . . . 316-234A
Weight Hanger Assy, Kubota . . . . . . . . . . . 316-276A
Section 2: Options & Accessories Set-up
p
Rear Gauge Wheel Installation
Figure 2-1
Side Gauge Wheel Installation
Figure 2-2
Weight Hanger Installation
Figure 2-3
1.
Attach weight hanger (#1) to reservoir with fourteen
1/2"-13 x 1 1/4" GR5 cap screws (#3) and hex flange
lock nuts (#5). Tighten lock nuts to the correct torque.
37253
37252
30029
NOTE:
The Case/International Harvest weight hanger
includes an L-shaped spacer. Locate this spacer between
weight hanger side plate and hydraulic reservoir tank.
