Section 2: Options & Accessories Set-up
5/24/19
DB2660 & DBM2660 Ditch Bank Rotary Cutter 316-317M
25
2.
Attach manual storage container (#9) to the front side
of the reservoir with two 1/4"-20 x 1 1/4" GR5 cap
screws (#4), flat washers (#7), and hex nylock
nuts (#6). Tighten nylock nuts to the correct torque.
3.
Insert weight retainer pin (#2) through holes in
weight hanger and secure with hairpin cotters (#8).
Bolt-on Weight Hangers
Refer to Figure 2-4:
The weight hanger is attached to the left side of the
hydraulic reservoir. See
on page 24 for attachment instructions.
IMPORTANT:
Adding weights to the reservoir can
lighten the tractor’s front end. Front tractor weights
and/or ballast to tires may be required to offset cutter
and auxiliary weights. Consult your tractor’s manual
to determine if additional ballast is needed.
IMPORTANT:
Suitcase type weights illustrated with
weight hangers are provided by the customer. Make
sure the suitcase weights are the same brand name
and match the weight hanger.
Not all suitcase
weights of the same brand name match Land
Pride weight hangers designed for that brand.
Bolt-on Weight Hangers
Figure 2-4
Bolt-on Weight Hanger Part No. 316-276A
Use Only with illustrated Kubota suitcase weights
Bolt-on Weight Hanger Part No. 316-231A
Use only with illustrated Case suitcase weights
Bolt-on Weight Hanger Part No. 316-232A
Use only with illustrated IH suitcase weights
Bolt-on Weight Hanger Part No. 316-233A
Use only with illustrated Case/IH suitcase weights
Bolt-on Weight Hanger Part No. 316-234A
Use Only with illustrated New Holland suitcase weights
Bolt-on Weight Hanger Part No. 316-230A
Use only with illustrated John Deere suitcase weights
Kubota Suitcase Weight
Case Suitcase Weight
International Harvest Suitcase Weight
Case/IH Suitcase Weight
New Holland Suitcase Weight
John Deere Suitcase Weight
30027
