LANCOM 3850 UMTS
Chapter 6: Point- to- point connections
58
EN
Configuration with
LANconfig
For configuration with LANconfig you will find the settings for P2P connec-
tions under the configuration area 'Interfaces' on the 'Wireless LAN' tab.
햲
Click on the button
Physical WLAN settings
to open the corresponding
WLAN interface and select the tab for 'Point-to-Point'.
햳
Activate the suitable point-to-point operation mode here and set the
channel selection scheme to either 'Master' or 'Slave'. Enter the approp-
riate MAC address for the WLAN card at the remote station (maximum 6).
Please observe that only the MAC addresses of the WLAN cards at the
other end of the connections are to be entered here! Not the access
point's own MAC address, and not the MAC addresses from any other
interfaces that may be present in the access points.
You will find the WLAN MAC address on a sticker below the corresponding
antenna connector. Only use the string that is marked as the "WLAN MAC" or
"MAC-ID". The other addresses that may be found are not the WLAN MAC
address but the LAN MAC address.
