LANCOM 3850 UMTS
Chapter 2: Installation
29
EN
햵
Connect up the power supply
– Use the supplied power supply unit to
provide the device with power via connector Use the supplied power sup-
ply unit to provide the device with power via connector
���
.
Use only the supplied power supply unit! The use of the wrong power
supply unit can be of danger to the device or persons.
You can alternatively use the PoE facility for the power supply (also see
'Power over Ethernet-elegant power supply over LAN cabling').
The LANCOM 3850 UMTS enables two LAN sockets to be used for red-
undant power supplies. The device itself selects the power source to
be used. If a power outage causes a switch between power sources,
the device reboots so that the power feed is reactivated.
햶
Operational?
– After a short device self-test the Power LED will be per-
manently lit green resp. will blink alternately red and green as long as no
configuration password has been given.
2.5
Software installation
The following section describes the installation of the Windows-compatible
system software LANtools, as supplied.
You may skip this section if you use your LANCOM Router exclusively
with computers running operating systems other than Windows.
2.5.1
Starting Software Setup
Place the product CD into your drive. The setup program will start automati-
cally.
If the setup does not start automatically, run AUTORUN.EXE in the
root directory of the product CD.
