![background image](http://html1.mh-extra.com/html/lancer/multi-valve-unit-tower/multi-valve-unit-tower_installation-and-operation-manual_3471348007.webp)
7
The “Pour/Cancel” button will illuminate and the “Shot”
button will blink 5 times.
NOTE
The brand’s water module will open and pour for 4
seconds to prime the separator. Only water will pour
during the flow rate check.
NOTE
If above or below 10 oz., adjust the water flow control.
Water should not be adjusted after this step.
NOTE
2. Press and hold the A and B brand buttons at the same time
for a minimum of 5 seconds.
3. Remove outer nozzle and insert syrup separator.
4. Place a ratio cup under the nozzle and press a brand button.
5. Press the brand button again to pour for 4 seconds.
6. Check for 10 oz of water in the ratio cup:
7. Repeat process for other water type.
8. Press Pour/Cancel to exit programming mode.
Ratio Process
1. Prime syrup by running the valve.
2. Press and fill the ratio cup to the appropriate level.
3. Check/Adjust Ratio on each brand.
4. Use flow controls to adjust syrup only. Do not adjust water.
5. Replace MVU front plate when all adjustments have been
made.
Portion Control Programming
1. Press the S and XL portion control size buttons at the same
time for a minimum of 5 seconds to enter portion setting
mode.
The “Pour/Cancel” button will illuminate and the “Shot”
button will blink 2 times.
NOTE