lancer CENTURIONII 85-0055, Installation And Service Manual

Page: 5 / 40

1. INSTALLATION (CENTURION II)
1.1 RECEIVING
Each unit is completely tested under operating conditions and thoroughly inspected before
shipment. At the time of shipment, the carrier accepts the unit and any claim for damage must be
made with the carrier. Upon receiving units from the delivering carrier, carefully inspect carton for
visible indication(s) of damage. If damage exists, have carrier note same on bill of lading and file a
claim with the carrier.
1.2 UNPACKING
A. Cut shipping band and remove.
B. Open top of carton and remove top inner carton pad from inside of packing box.
C. Open top inner carton pad and remove drip tray containing four (4) legs (PN 81-0112) and
accessory kit of loose parts (contents listed below).
QUANTITY PART DESCRIPTION PART NO.
1 Brush 22-0017
2 Flare Seal Washer 05-0017
2 Dispensing Nozzle 54-0038
1 Product Plate - Orange 05-0190
1 Product Plate - Grapefruit 05-0192
1 Product Plate - Apple 05-0194
1 Product Plate - Lemonade 05-0193
1 Product Plate - Limeade 05-0196
1 Product Plate - Pineapple 05-0197
1 Product Plate - Five Alive 05-0384
1 Product Plate - Fruit Punch 05-0385
2 Product Plate - Grape 05-0191
2 Product Plate - Cranberry 05-0195
2 Keys (for Key Switch) 81-0126
1 Inlet Water Shut Off 49-0226
2 Pushbutton Assembly 82-0482
1 Pushbutton Template 06-0341
1 Switch 12-0087
D Remove outer carton and bag by lifting up.
E. Lift unit by plywood shipping base and remove lower portion of carton.
F. Remove plywood shipping base from unit by removing screws from bottom. This is best done
by moving unit so that one side extends past edge of counter top or table allowing access to
screws on bottom of plywood shipping base.
G. Assemble legs (PN 81-0112) to unit by tilting unit. DO NOT LAY UNIT ON ITS SIDE OR BACK.
H. Inspect unit for concealed damage and if evident notify delivering carrier and file a claim against
same.
NOTE
If unit is to be transported, it is advisable to leave unit secured to plywood shipping base.
1.3 SELECTING COUNTER LOCATION
A. Select a location close to a properly grounded electrical outlet and water supply that meet the
requirement as listed in the Specifications (page iii).
1