3
4
HArDwArE/TOOLS
HARDWARE
BREW EXPRESS™ comes supplied with the following items to ensure a successful installation.
Check to be certain all items have been included with your brewer.
•
(1) Brewer (with short water line attached to connect with incoming water line)
•
(1) Rough-in-Box
•
(1) Carafe and lid
•
(2) Brew Baskets
•
(1) Installation Guide
•
(1) Operation Guide
•
(1) Template (for cutting hole for Rough-in-Box)
•
(1) Hardware Kit: (located in foam end cap)
(6) Sheet rock screws for mounting rough-in-box.
(3) Wire nuts
(1) Male Quick Connector (for connection between Coffee System Unit and Rough-in-Box).
(4) Mounting screws for mounting brewer in rough-in-box.
TOOLS REQUIRED
The following tools will be useful for installation:
•
Tape Measure
•
Utility Knife
•
Phillips Screw Driver
•
Pencil
•
Wire Stripper
•
Stud Finder
•
Pliers
•
Level
PARTS REQUIRED
(not supplied)
•
Strain relief (Romex wire clamp)
•
1/4" Poly or copper line (refrigerator ice maker kit)
continuous length recommended.
•
12 - 2 wire (per local code)
•
Caulking Gun
•
Silicone Caulk
•
Safety Glasses
•
AC Power Sensor
•
Crescent Wrench
•
Reciprocating Saw (optional)
•
Tile Cutting Bit (optional)
•
Electric drill and drill bits
GET TING STArTED
•
Valve Connection (optional)
•
Water filter
• Wire Nuts
IMPORTANT:
Read and follow instructions carefully before installing your BREW EXPRESS™ in-the-wall
COFFEE SYSTEM. For best results its advised that you hire a qualified professional.
Getting Started
1.
Carefully unpack BREW EXPRESS™ from gift box.
2.
Remove hardware kit from foam packaging.
3.
Remove carafe from brewing unit and set aside.
4.
Remove mounting screws using a Phillips screwdriver
(note - if screws are not present look in hardware kit).
5.
Separate brewer from Rough-In-Box by holding the
Rough-In-Box with one hand, and pulling the brewer with
the other hand (see figure below).
2
2
Hold unit by placing
one hand here
Pull here to remove brewer
from Rough-In-Box
