Lanberg © 2015-2020
20
EN
Before you go any further make sure to
check whether the assembly is progressing
correctly. Remember to place the side cabinet
frame so that:
I) Attached M6 Cage nuts are on the top.
II) Vertical rail numbering is increasing from
right to left
. The reference points are the wall-
mount holes on the rear cabinet structure.
The highest “U” numbering on the vertical
mounting rails must be above these holes.
5. Fix the side frame with 2 (< 21 U) or 3 (>= 21 U)
M6*12 Phillips screws [A], screwing them from
top to bottom.
1. Fit the
2nd
side frame
[K]
to the nearest side of the rear cabinet structure
[L]
.
Before you go any further make sure to check whether the assembly is progressing correctly. Remember to place the side cabinet
frame so that:
I) Attached M6 Cage nuts are on the top.
II) Vertical rail numbering is increasing from
left to right
. The reference points are the wall-mount holes on the rear cabinet
structure. The highest “U” numbering on the vertical mounting rails must be above these holes.
2. Fix the side frame with 2 (< 21 U) or 3 (>= 21 U) M6*12 Phillips screws [A], screwing them from top to bottom.
3. Rotate the cabinet 180 degrees.
4. Align the
1st
side frame
[J]
with the second side of
cabinet’s rear cover
[L]
.
2.2.2. Installation of side panels with the rear cover
When screwing, remember to hold the sides of the
elements together. Otherwise, their displacement may
hinder the assembly, later on.
2
3
4
5
6
7
8
9
1
2
1
