6
Installation of the Machine
Stand is assembly type. Use hex wrench to install the stand while being careful about left and right directions.
※
③
with re-winding power switch should be installed on the right stand when looked from the front.
When looked from the front, there is an insertion hole of foot switch at
the center of the right surface.
Convex surface prevents insertion in incorrect direction. Check the
shape of the insertion hole before inserting.
(Excessive force causes damage the part.)
When disconnect the cable, Remover lock by pulling it.
When looked from the front, insert the cable sticking out from the rear
side of the main body into the power insertion hole of the re-winding
device.
※
Do not insert power re-winding device cable into other power
holes. It may cause device failure.
Power Connection for Re-Winding Device
Foot Switch Installation Method
Stand Assembly Method
①M6 screw (4 EA x 2 places)
②M6 screw 2 EA
③M6 screw 2 EA
Power switch
Fuse box
Power inlet
Re-Winding device
