Lamborghini Caloreclima ERA 31 B 130, Installation And Maintenance Manual

Page: 40 / 100

40
PARAMETER SETTING
The electronic control of the electrical panel for floor-standing boilers allows configuring some parameters (28)
relating to special functions of the panel.
Such parameters can be displayed and/or edited on the LCD with the Up and Down buttons on the
electrical panel, through an access key that can be activated by pressing and together for 3
seconds. The abbreviation PAS is displayed on the hour and minute digits (exit is after a 30
second Timeout); after entering a 2-digit code with and , on the temperature digits
press and the control will check the entered code. If it is correct, the identification (Id) of the first parameter
being programmed is proposed. Each parameter is identified by letter P and by a progressive number from 01
to 28 on the display, on the hour and minute digits . The value of each parameter identified by the
abbreviation can be edited with and , in a range of values defined in the table (min and max). The
data value is shown on the display, on the temperature digits if it does not relate to the hour
counter, whereas each value relating to the hour counters is displayed on the hour counter digits, .
Two passwords are defined, one with code “05” , that allows accessing the table parameters from P01 to P02
included, and the other with code
“77”
, that allows accessing all parameters. The table shows the default
values of each parameter (valid at the first ignition with “non-initialised” Eeprom).
Parameters are stored in Eeprom, NON-volatile memory, with guarantee of data retaining up to 10 years.
Once entered in the parameter programming step, each parameter is selected with forward and
backward. Exit the “protected” parameter programming step after a 30 second Timeout or by pressing ,
or after the last selectable parameter, P28.