Lakeshore 336, User Manual

Page: 62 / 192

50 c
HAPTER
4: Operation
Model 336 Temperature Controller
D
Input and Units: each available display location has an associated Input and Units
setting. The Input parameter determines which sensor will be used as the input
of the displayed data. The Input can be any of the four sensor inputs, or None. If
None is selected, then the display location will be blank. The Units parameter
determines which units to display the reading in.
Menu Navigation:
Display Setup
Q
Location (1, 2, 3, 4, 5, 6, 7, 8) Input
Q
(None, Input A, Input B,
Input C, Input D)
Display Setup
Q
Location (1, 2, 3, 4, 5, 6, 7, 8) Units
Q
(Kelvin, Celsius, Sensor,
Min, Max, Sensor Name)
Interface Command:
DISPFLD
D
Displayed Output: in the Custom Display mode the bottom half of the display is
dedicated for output and control loop information for one of the four outputs.
The source of this information depends on the output selected for the Displayed
Output parameter. If the selected output is configured as a control loop output,
then all associated control loop parameters will be displayed.
When viewing the Custom Display screen, the configured Displayed Output is
signified by L1, L2, L3 or L4, followed by the control loop input, if applicable. The L
character stands for Loop, but will be displayed even for outputs that are not con-
figured as control loop outputs.
Menu Navigation:
Display Setup
Q
Displayed Output
Q
Output (1, 2, 3, 4)
D
Default: Output 1
Interface Command:
DISPLAY
Location Input Units
1 Input A
Kelvin
2 Input B
3 Input C
4 Input D
5 Input A
Sensor
6 Input B
7 Input C
8 Input D
TABLE 4-6 Defaults