laguna Fusion F3, Manual

Page: 32 / 68

Fusion F3 Table Saw - Setup - Rear Rail 32
© 2020 Laguna Tools
Top View: Front View:
Rear View: Hose support and Leg properly Installed:
Attaching the Right Rear Rail Bracket to the Table:
1. Align the right rear rail bracket’s bolt holes with the bolt holes located on the back of the table as shown below:
2. Thread 1 socket head cap screws and lock washer through the rear rail and table’s through holes. At this stage, only
three socket head cap screws should be used to secure the rail to the table (see above image).
3. Thread flat washer and hex nut and snugly tighten, allowing play.
After completing step two, there should be two through holes in the middle of the front rail bracket which
have not been used yet. These should be empty as they will be used later to mount the right extension table (shown above
as red circles)