Laguna Tools SmartShop Maker, Owner'S Manual

Page: 19 / 70

SmartShop|Maker Owner’s Manual
19
5.0 Assembly and Setup
Once the SmartShop|Maker has been properly placed on the floor and leveled, the machine is
ready for the placing of the vacuum pump(s) and connections to electricity and air.
5.1 Electrical Requirements
The SmartShop|Maker requires permanent, direct power installed by a qualified electrician
familiar with industrial best practices. Ensure that all power cords are protected from traffic,
moisture, chemicals, or other hazards. For safety, always have a qualified electrician assess
grounding and any further electrical needs.
5.2 Electrical Connections
The main power cable (not supplied) must be connected to the main disconnect switch on the
front of the electrical cabinet. Power cables must also be connected to the vacuum pump(s). A
qualified electrician must carry out the electrical installation of the SmartShop|Maker.
1. Contactors to vacuum pumps
2. Main Disconnect incoming power connections
3. Vacuum pump and Main Power grounds
Figure 5-1: Electrical Connections