Laguna Tools PX-20 SHEARTEC II, Owner'S Manual

Page: 12 / 76

12
Electrical Safety (Cont’d.) -
A Electrical Cord and Plug is not provided with Ordered
Machine.
Make sure to follow Electrical Installation stated in the instructions below.
If this information is different than what is stated on the Motor Specification Plate - omit this
information. It is possible that the documentation is outdated to a machine change - such as a
different motor. Always check the motor plate prior to any wiring. If any doubts, please consult a
certified electrician. Know when to use a time delay fuse! AKA Slow blow fuse. Generally, if the
motor uses a start capacitor, a time delay fuse is required. This type of fuse (circuit breaker) will
not trip with the initial amperage needed to start the machine, which is typically double that of
the running amperage. Most woodworking machines use this type of fuse.
Electrical Safety-
Electrical Cord and Plug is not provided with Ordered Machine.
Make
sure to have a Qualified Electrician install required a qualified/standardized electrical cord and
plug for purchased machine.
*Electrical Code that must be met in your local state (USA) or
province (CSA). An electrician will verify that all the demands are met to properly wire the
machine. If you have absolutely any doubt when wiring this machine -
please consult with a
Qualified Electrician .