Lagler UNICO, Operation, Maintenance And Safety Manual

Page: 14 / 56

UNICO 01.02.2013
English / Englisch
Fig. 8 Install the Velcro strip carefully to ensure properly
sealing.
Fig. 7 The pressure hose can also be rotated at the lower
plastic pipe stub.
Fig. 6 Inserting the cable rod into the proper bracket.
4.2 SWIVELLING THE PRESSURE HOSE
For your sanding work, the pressure hose can be rotated toward the
left or right depending whether you standing on the right-hand side
or on the left-hand side of the machine or whether you are kneeling
or bending down. This ensures a constant volumetric flow of the air
being sucked into the machine.
1 On the pressure hose, grab the black plastic pipe stub below
the hose piece and rotate it toward the desired side. The dust
bag will swivel with the black plastic pipe stub (Fig. 7). Do not
use the upper curved pipe piece to rotate the pressure hose.
2 Whenever appropriate, make sure that the dust bag is properly
positioned without any folds.
4.3 INSTALLING THE VELCRO STRIP
Depending on the thickness of the abrasive in each case, the Velcro
sealing strip on the attachment must be repositioned in order to
improve the airflow conditions at the front end of the attachment
and to seal off the sanding zone from the surrounding area.
1 Switch off the machine.
2 For safety reasons, always pull the power supply plug out
of the socket to prevent the machine from being started up
unintentionally!
3 Fasten the Velcro strip by one end of the adhesive strip to the
attachment and then place it all the way around the attach-
ment (Fig. 8).
4 On the front side of the machine, the Velcro strip should be
about 1 mm away from the floor in order to be able to provide
an air inlet. At all other locations, the strip is supposed to be
resting on the floor.
5 The Velcro strip must be renewed whenever it is worn-out.
However, you can, of course, also use the upper edge of the
Velcro strip after turning it over.
4
COMMISSIONING
14