laerdal VitalsBridge 100, Directions For Use Manual

Page: 11 / 45

VitalsBridge Directions for Use
10
rev. A.5
The VitalsBridge instrumentation has 5 LEDS: Power, battery/charge, USB/Serial, Bluetooth and LAN/WiFi.
- Power indicator:
o
No light: switched off, or switched on and the VitalsBridge is not plugged into an outlet
o
Solid: switched on and power available to the VitalsBridge
- Battery/charge indicator:
o
No light: VitalsBridge is not running
o
Solid: VitalsBridge is on, battery charge > 15%
o
Flashing every 1 second: unit is running on low battery charge < 15%
- USB/Serial
o
No light: USB is not ready
o
Solid: USB is ready
- Bluetooth
o
No light: Bluetooth is not ready
o
Solid: Bluetooth is ready
- WLAN or LAN:
o
No light: not connected to router
o
Solid: the VitalsBridge is connected to the manikin’s internal router or to an external router
Note: If you have just reconfigured your VitalsBridge to connect to WiFi, the light will not turn on until
you have first closed out of the VitalsBridge Connector software.
Internal Battery
The VitalsBridge contains an internal, non-replaceable Lithium-Ion battery to allow for unplugged operation of the unit.
When fully charged, this will allow for at least 1 hour of use (2
– 3 hours typical). To charge the battery, connect the
external power supply. The power supply will charge a fully depleted battery in 6-12 hours. When the unit is switched
on, the battery indicator on the top panel will flash when there is less than 10% of battery life remaining; if you need to
continue using the VitalsBridge, connect the external power.
When plugged in and powered off, the VitalsBridge battery will be charged. When plugged in and powered on, the
VitalsBridge battery will also be charged (at a slower rate).