laerdal SimMan 3G Trauma, Directions For Use Manual, Page: 17 / 64

14
Manikin Setup
Setup f
or Sim
ulation
Clinical F
eatur
es
Maintenance
Tr
oubleshooting
Spar
e Par
ts
System Setup
System Setup
WIRELESS AND LAN CONFIGURATION
The SimMan3G Network Configuration Tool (SNCT) allows you to
configure the network behavior of the SimMan3G manikin.
For more information on Wireless and LAN configuration, see the
SimMan3G Network Configuration Tool Help file (Press the <F1>
key on the PC keyboard).
Configuring Your Network
The SimMan3G is equipped with a small router that provides WLAN
connectivity. This router can be configured two ways: Either the
manikin creates a wireless network (Access Point mode) or the
manikin is hooked up to an already existing network (station/client
mode). The mode of operation is selected by changing a switch on
the router, located inside the manikin’s pelvis.
Manikin created network (Access point mode) [default]
The default operation is AP, i.e. where manikin creates a wireless
network. The switch on the router is set in AP mode. The manikin is
set up to create a network called SimMan3G. WPA2/PSK-AES is the
preferred security/encryption setting and also the default. The default
preshared key is SimMan3G. This should however be changed with
the SimMan 3G network configuration tool.
Connecting to an Existing Network
If you would like to connect your manikin and the Instructor PCs to
an already existing network, please move the switch on the router
to the client mode, ref picture above. Please use the SimMan3G
Network Configuration Tool to enable connection to an already
existing network.
Wired operation (disabling/enabling WLAN)
The wireless network may be disabled in AP mode. This can be
achieved by using the SimMan3G Network Configuration Tool. When
using manikin in environments where use of WLAN transmitters are
prohibited: Contact your local service representative for instructions
on how to turn off radio transmission.
Removing/Changing router
The router may be changed or removed. Turn off the manikin before
doing so.
Open the pelvis and locate the router. Remove the two Ethernet
cables and black power cable.
If you would like to operate the manikin without a router, then attach
a through-adapter between the two Ethernet cables.
If you would like to install a new router, attach the power cable to the
DC plug and the Ethernet cables back into the router again.
USB Reset Router AP Client USB Reset Router AP Client