Genitalia –
Both male and female genitalia have been provided for
urinary catheterization and enema training procedures.
Valve tubes, with a screw cap on
one end, will connect urethra and anus
to corresponding reservoirs. This cap
must be connected to genitalia openings.
Soft vinyl end of connector is attached
to urinary and anal reservoirs with
a white C-clamp. (Long valve connects
urinary reservoir; short valve connects
anal reservoir.)
Pelvic support pin must be removed and
replaced immediately when assembling
and disassembling genitalia.
(Figure3).
To assemble:
1.
Screw both valves onto genitalia.
When attaching valves, be sure
alignment of genitalia, urinary
reservoir (belly plate) and colon
reservoir
are as illustrated in Figure 4.
2.
Lift up on edge of belly plate.
Laerdal
Recommends:
Pelvic support
pin must be
replaced.
Failure
to replace pin will
result in pelvic
spread.
If this occurs, the
genitalia module will
no longer fit
properly in the
manikin.
Fig. 3
Fig. 4
3.
Pull down upper portion of genital.
4.
Insert into pelvic cavity.
5.
Replace the pelvic support pin.
6.
Press belly plate into position.
301-00001
Laerdal
9
Summary of Contents for Patient Kelly
Page 1: ...Patient Kelly Directions for Use...
Page 2: ...301 00001 Laerdal 2...
