Lada GRANTA, User Manual

Page: 10 / 140

REMOTE CONTROL
SYSTEM OPERATION
1. Door locks locking and pro-
tection mode activation (in the
design variant) with the help of
remote control panel.
For locking the door locks and the
protection mode activation, press
the lock button
on the panel. At
that, the locks of the side doors will
be locked, in parallel the protection
mode will be activated, which is con-
firmed by single flashing of turn indi-
cators and slow flashing of immobi-
lizer state LED
in the instrument
cluster.
In case upon the protection mode
activation, any door, bonnet or trunk
compartment is open
(in the design
variant) , the turn indicators will blink
three times and a single beep will be
emitted. In order to include open
zones into the protection zone, close
them. The system similar behaviour
will be exercise in case of the side
doors locks overheat control trip-
ping, if the locks locking (unlocking)
occurs time and time again during
short intervals. In such case wait for
some time, after that the system
operability will be fully restored.
2. Door locks unlocking and
protection mode disabling with
the help of remote control panel.
Door locks unlocking with the help
of remote control panel is possible in
two modes:
– step by step unlocking (factory
supply);
– simultaneous unlocking (particu-
lar procedure execution is required –
see below).
To unlock the driver's door lock
with the help of remote control panel
in the step by step unlocking mode
press the unlock push-button
on
the panel. The driver's door lock will
be unlocked and the protection
mode disabling is accompanied by
the double blinking of turn indica-
tors.
To unlock the passenger doors
press the unlock push-button on
the panel once again.
In the simultaneous unlocking
mode, during the first pressing on
the push-button all vehicle doors
simultaneous unlocking occurs.
The unlocking mode change is
performed according to the following
procedure:
– switch on the ignition with the
key on the panel;
– press the lock and unlock
push-buttons on the panel simulta-
neously and hold them for about five
seconds;
– after the buzzer beeps release
the push-buttons.
If the buzzer emitted one beep, it
means that the simultaneous mode
of unlocking the doors is set, and if
the buzzer gave two beeps, then the
step-by-step mode of unlocking the
doors is set. During every unlocking
mode change procedure it is
changed for the one contrary to set
before that.
In case after the doors unlocking
and the protection mode disabling,
no door or trunk lid is open and the
ignition does not switch on, then
after a certain time (about 25 sec-
onds) the doors will be locked again
and the system will switch to the pro-
tection mode automatically. The sys-
tem automatic switching to the pro-
tection mode along with the doors
locking is followed by the immobiliz-
er LED frequent blinking
in the
instrument cluster.
Warning
When holding the lock push-
button on the remote control
panel in depressed position for
more than 3 seconds, the rolling
up of the pulled down door win-
8