51
Problem: Color camera images are in B&W
Possible Cause
Resolution
Imaging settings mis-
adjusted
go to Video>Color Format> and ensure 24-bit RGB is selected.
go to Video>Properties>Video Proc Amp and maximize the
Saturation setting. Adjust Brightness, Contrast and Hue to optimize
the image.
Problem: Error Message “Failed to connect to LUT converter” and/or “Cannot Give Graph
to Builder”
Possible Cause
Resolution
incompatible video
device selected, or
switching between
video capture devices
If an incompatible video capture source is selected (such as VDP
source) or if you switch between capture sources you may get
errors, even when you go back and choose the correct source. Shut
down the uScope software, turn off the SVM, and then restart the
SVM and software and select the correct source.
For Analog Optics Module: If the errors persist, go to Video>Image
Size and Format and select 720 x 480 for Output Size.
7.2
Getting help
This guide is your main source for information on operating the SVM340 and the uScope
software. Check the LabSmith web site (www.labsmith.com) for user manual updates,
application notes and information to help you use the SVM340.
If you are unable to find the help you need, contact LabSmith technical support at (925) 292
5161 or
. Please write down the serial number of your SVM340 (located
on the bottom of the unit) and the version of the software you are using. To get the software
version number, click
Help>About uScope
in the uScope main window.
